RAB Holder, also called Raspberry Pi, Arduino and Breadboard Holder. Presumably you can noqueado its function from the name. It can ensure the security of your demoboard and avoid placing the demoboard on the desk freely to cause short cut. The RAB Holder also simplifies your experiment when you are building a complex circuit. There are three zones on the RAB Holder and each has a name on it. We have made some slots in the zone that used to fix the Raspberry Pi to make the use more comfortable.A screwdriver is provided for you to install the Raspberry Pi and Arduino board onto the holder with screws.
2 *M3*10 Screw
4 *M2.5*6 Screw
6 * M3*6 Screw
1 * RAB Holder
1 x Screwdriver
Compatibale with Raspberry Pi 3 Model B,2 Model B and 1 Model B+.
Any Arduino board whose mounting holes are the same with UNO and Mega 2560 can be fixed upon this Holder with screws.
Be able to fix the 400 points and 800 points self-adhesive breadboard.
There are M3 fixing holes in the middle which can be used to fix the RAB Holder upon your experiment table.
Size: 200*135mm ->7.87inch * 5.31inch.